DLP-RFID1-RG DLP Design Inc, DLP-RFID1-RG Datasheet - Page 6
![RFID Modules & Development Tools RFID Reader (Retail Box Version)](/photos/15/98/159812/812007101013_sml.jpg)
DLP-RFID1-RG
Manufacturer Part Number
DLP-RFID1-RG
Description
RFID Modules & Development Tools RFID Reader (Retail Box Version)
Manufacturer
DLP Design Inc
Datasheet
1.DLP-RFID1-RG.pdf
(7 pages)
Specifications of DLP-RFID1-RG
Operating Current
15 mA
Output Power
200 mW
Product
RFID Readers
Wireless Frequency
13.56 MHz
Interface Type
USB
Dimensions
79.3 mm x 55.1 mm x 5.1 mm
Antenna
On-Board
Operating Temperature Range
0 C to + 70 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
9.2 INTEGRAL ANTENNA
The DLP-RFID1 is approved for use with the integral antenna only. Modifying the DLP-RFID1’s PCB
antenna or modifying the PCB to use an external antenna will void all agency compliance approvals.
A location for mounting an SMA connector (purchased separately) is available on the DLP-RFID1’s
printed circuit board. Mounting the SMA connector requires the removal of the RF shield from the PCB.
Additionally, the on-board antenna must be isolated from the signal path leading to the SMA connector
via the removal of capacitor C37. This output is designed to drive a 13.56MHz, 50-Ohm antenna. The
use of any other type of antenna may cause permanent damage to the DLP-RFID1.
9.3 FCC/IC REQUIREMENTS FOR MODULAR APPROVAL
Any changes or modifications to the DLP-RFID1’s printed circuit board could void the user’s authority to
operate the equipment.
9.4 WARNINGS
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesirable operation.
This device is intended for use under the following conditions:
1. The transmitter module may not be co-located with any other transmitter or antenna; and
2. The module is approved using the FCC’s “unlicensed modular transmitter approval” method.
As long as these two conditions are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance measures
necessitated by the installation of this module (i.e. digital device emissions, PC peripheral requirements,
etc.).
Note: In the event that these conditions cannot be met (i.e. co-location with another transmitter), then
the FCC authorization is no longer valid, and the corresponding FCC ID may not be used on the final
product. Under these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
9.5 OEM PRODUCT LABELING
The final end product must be labeled in a visible area with the following text:
“Contains TX FCC ID: SX90RFID1”
9.6 RF EXPOSURE
In order to comply with FCC RF exposure requirements, the antenna used for this transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
2006 (Preliminary Data)
www.dlpdesign.com
sales@dlpdesign.com