DS92LV2411SQ/NOPB National Semiconductor, DS92LV2411SQ/NOPB Datasheet - Page 35

• Manufacturer Part Number: DS92LV2411SQ/NOPB
• Description: IC SERIALIZER 24BIT 48LLP
• Manufacturer: National Semiconductor

Specifications of DS92LV2411SQ/NOPB

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Applications Information
DISPLAY APPLICATION
The DS92LV2411/DS92LV2412 chipset is intended for inter-
face between a host (graphics processor) and a Display. It
supports an 24-bit color depth (RGB888). In a RGB888 ap-
plication, 24 color bits (D[23:0), Pixel Clock (CLKIN) and three
control bits (C1, C2, C3) are supported across the serial link
with CLK rates from 5 to 50 MHz. The chipset may also be
used in 18-bit color applications. In this application three to
six general purpose signals may also be sent from host to
display.
The Des is expected to be located close to its target device.
The interconnect between the Des and the target device is
typically in the 1 to 3 inch separation range. The input capac-
itance of the target device is expected to be in the 5 to 10 pF
range. Care should be taken on the CLK output trace as this
signal is edge sensitive and strobes the data. It is also as-
sumed that the fanout of the Des is one. If additional loads
need to be driven, a logic buffer or mux device is recom-
mended.
FIGURE 32. DS92LV2411 Typical Connection Diagram — Pin Control
35
TYPICAL APPLICATION CONNECTION
Figure 32
DS92LV2411 Ser in pin control mode for a 24-bit application.
The CML outputs require 0.1 µF AC coupling capacitors to the
line. The line driver includes internal termination. Bypass ca-
pacitors are placed near the power supply pins. At a minimum,
four 0.1 µF capacitors and a 4.7 µF capacitor should be used
for local device bypassing. System GPO (General Purpose
Output) signals control the PDB and BISTEN pins. In this ap-
plication the RFB pin is tied Low to latch data on the falling
edge of the CLKIN. In this example the cable is long, therefore
the VODSEL pin is tied High and a De-Emphasis value is se-
lected by the resistor R1. The interface to the host is with 1.8
V LVCMOS levels, thus the VDDIO pin is connected also to
the 1.8V rail. The optional Serial Bus control is not used in this
example, thus the SCL, SDA and ID[x] pins are left open. A
delay cap is placed on the PDB signal to delay the enabling
of the device until power is stable.
shows a typical connection diagram of the
30065344
www.national.com