SX1212IWLTRT Semtech, SX1212IWLTRT Datasheet - Page 28

• Manufacturer Part Number: SX1212IWLTRT
• Description: IC TXRX 300MHZ-510MHZ 32-TQFN
• Manufacturer: Semtech

Specifications of SX1212IWLTRT

• Frequency: 300MHz ~ 510MHz
• Data Rate - Maximum: 150kbps
• Modulation Or Protocol: FSK, OOK
• Applications: AMR, ISM, Home Automation, Process Control
• Power - Output: 12.5dBm
• Sensitivity: -110dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 3mA
• Current - Transmitting: 25mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-TQFN
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Modulation Type: FSK/OOK
• Package Type: TQFN EP
• Operating Supply Voltage (min): 2.1V
• Operating Supply Voltage (typ): 2.5/3.3V
• Operating Supply Voltage (max): 3.6V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Supplier Unconfirmed
• Other names: SX1212IWLTR

The effect of the Fdev setting is different between FSK and OOK modes:
In FSK mode the Fdev setting, as configured by MCParam_Freq_Dev, sets sampling frequencies on the receiver.
The user should make it consistent with the frequency deviation of the FSK signal that is received.
The frequency deviation Fdev, as described above, sets the sampling rate of the RSSI block. It is therefore
necessary to set Fdev to the recommended low-IF frequency, IF2, of 100 kHz:
The FSK demodulator provides data polarity information, based on the relative phase of the input I and Q signals at
the baseband. Its outputs can be fed to the Bit Synchronizer to recover the timing information. The user can also
use the raw, unsynchronized, output of the FSK demodulator in Continuous mode.
The FSK demodulator of the SX1212 operates most effectively for FSK signals with a modulation index greater
than or equal to two:
The OOK demodulator performs a comparison of the RSSI output and a threshold value. Three different threshold
modes are available, programmed through the RXParam_OOK_thresh_type register.
The recommended mode of operation is the “Peak” threshold mode, illustrated below in Figure 22:
Rev 2 – June 18th, 2009
ADVANCE
3.4.8. Fdev Setting in Receive Mode
3.4.9. FSK Demodulator
3.4.10. OOK Demodulator
D COMMUNICATIONS & SENSING
RXParam_RSSI_val(7:0)
IRQParam_RSSI_irq
3.4.8.1. FSK Rx Mode
3.4.8.2. OOK Rx Mode
24 26 27 30 25 20 20 20 18 22
MCParam
Fdev
Figure 21: RSSI IRQ Timings
=
IF
β
2 =
_
=
Freq
Page 28 of 77
100
2
*
BR
Fdev
kHz
_
dev
Clear interrupt
≥
=
"
2
00000011
"
33
20 22 34
33
www.semtech.com
SX1212