XC68HC705B32CB Freescale Semiconductor, XC68HC705B32CB Datasheet - Page 87

• Manufacturer Part Number: XC68HC705B32CB
• Description: IC MCU 2.1MHZ 32K OTP 56-DIP
• Manufacturer: Freescale Semiconductor
• Series: HC05r

Specifications of XC68HC705B32CB

• Core Processor: HC05
• Core Size: 8-Bit
• Speed: 2.1MHz
• Connectivity: SCI
• Peripherals: POR, WDT
• Number Of I /o: 32
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Eeprom Size: 256 x 8
• Ram Size: 528 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 56-SDIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

After loading the last byte in the serial communications data register and receiving the TDRE flag,
the user should clear TE. Transmission of the last byte will then be completed and the line will go
idle.
RE — Receiver enable
When RE is clear (receiver disabled) all the status bits associated with the receiver (RDRF, IDLE,
OR, NF and FE) are inhibited.
RWU — Receiver wake-up
When the receiver wake-up bit is set by the user software, it puts the receiver to sleep and enables
the wake-up function. The type of wake-up mode for the receiver is determined by the WAKE bit
discussed above (in the SCCR1). When the RWU bit is set, no status flags will be set. Flags which
were set previously will not be cleared when RWU is set.
If the WAKE bit is cleared, RWU is cleared by the SCI logic after receiving 10 (M = 0) or 11 (M =1)
consecutive ones. Under these conditions, RWU cannot be set if the line is idle. If the WAKE bit is
set, RWU is cleared after receiving an address bit. The RDRF flag will then be set and the address
byte stored in the receiver data register.
SBK — Send break
If the send break bit is toggled set and cleared, the transmitter sends 10 (M = 0) or 11 (M = 1)
zeros and then reverts to idle sending data. If SBK remains set, the transmitter will continually
send whole blocks of zeros (sets of 10 or 11) until cleared. At the completion of the break code,
the transmitter sends at least one high bit to guarantee recognition of a valid start bit.
MC68HC05B6
Rev. 4.1
1 (set)
0 (clear) –
1 (set)
0 (clear) –
–
–
Transmitter enabled.
Transmitter disabled.
Receiver enabled.
Receiver disabled.
SERIAL COMMUNICATIONS INTERFACE
Freescale
6-15
6