XC68HC705B32CB Freescale Semiconductor, XC68HC705B32CB Datasheet - Page 259

• Manufacturer Part Number: XC68HC705B32CB
• Description: IC MCU 2.1MHZ 32K OTP 56-DIP
• Manufacturer: Freescale Semiconductor
• Series: HC05r

Specifications of XC68HC705B32CB

• Core Processor: HC05
• Core Size: 8-Bit
• Speed: 2.1MHz
• Connectivity: SCI
• Peripherals: POR, WDT
• Number Of I /o: 32
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Eeprom Size: 256 x 8
• Ram Size: 528 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 56-SDIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

E6LAT — EPROM programming latch enable bit
STOP, power-on and external reset clear the E6LAT bit.
Note:
E6PGM — EPROM program enable bit
This bit is the EPROM program enable bit. It can be set to ‘1’ to enable programming only after
E6LAT is set and at least one byte is written to the EPROM. It is not possible to clear this bit using
software but clearing E6LAT will always clear E6PGM.
Note:
ECLK
See
E1ERA — EEPROM erase/programming bit
Providing the E1LAT and E1PGM bits are at logic one, this bit indicates whether the access to the
EEPROM is for erasing or programming purposes.
Once the program/erase EEPROM address has been selected, E1ERA cannot be changed.
MC68HC05B6
Rev. 4.1
Section
1 (set)
0 (clear) –
1 (set)
0 (clear) –
After the t
to zero in order to clear the E6PGM bit.
All combinations are not shown in the above table, since the E6PGM bit is cleared when
the E6LAT bit is at zero, and will result in a read condition.
4.3.
–
–
ERA1
Address and up to sixteen data bytes can be latched into the EPROM
for further programming providing the E6PGM bit is cleared. When
programming the EPROM, all other 15 addresses must be latched
with the erased state ($00) or corruption may occur.
Data can be read from the EPROM or firmware ROM; the E6PGM bit
is reset to zero when E6LAT is ‘0’.
An erase operation will take place.
A programming operation will take place.
E6LAT E6PGM
0
1
1
erase time or t
Table H-2 EPROM control bits description
0
0
1
Read/execute in EPROM
Ready to write address/data to EPROM
programming in progress
MC68HC705B32
PROG1
programming time, the E6LAT bit has to be reset
Description
Freescale
H-9
14