ATMEGA162L-8MI Atmel, ATMEGA162L-8MI Datasheet - Page 238

• Manufacturer Part Number: ATMEGA162L-8MI
• Description: IC MCU AVR 16K 3V 8MHZ 44-QFN
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA162L-8MI

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: EBI/EMI, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 35
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-VQFN Exposed Pad
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Data Converters: -

Programming the Fuse High
Bits
Programming the Extended
Fuse Bits
Figure 100. Programming the FUSES Waveforms
238
RESET +12V
RDY/BSY
PAGEL
XTAL1
ATmega162(V/U/L)
DATA
BS2
XA1
XA0
BS1
WR
OE
0x40
A
DATA
C
Write Fuse Low byte
XX
The algorithm for programming the Fuse high bits is as follows (refer to “Programming
the Flash” on page 234 for details on Command and Data loading):
1. A: Load Command “0100 0000”.
2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse bit.
3. Set BS1 to “1” and BS2 to “0”. This selects high data byte.
4. Give WR a negative pulse and wait for RDY/BSY to go high.
5. Set BS1 to “0”. This selects low data byte.
The algorithm for programming the Extended Fuse bits is as follows (refer to “Program-
ming the Flash” on page 234 for details on Command and Data loading):
1. 1. A: Load Command “0100 0000”.
2. 2. C: Load Data Low Byte. Bit n = “0” programs and bit n = “1” erases the Fuse
3. 3. Set BS1 to “0” and BS2 to “1”. This selects extended data byte.
4. 4. Give WR a negative pulse and wait for RDY/BSY to go high.
5. 5. Set BS2 to “0”. This selects low data byte.
bit.
0x40
A
DATA
C
Write Fuse high byte
XX
0x40
A
DATA
C
Write Extended Fuse byte
XX
2513C–AVR–09/02