UPD78F0513AMC-GAA-AX Renesas Electronics America, UPD78F0513AMC-GAA-AX Datasheet - Page 285

• Manufacturer Part Number: UPD78F0513AMC-GAA-AX
• Description: MCU 8BIT 38PIN SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AMC-GAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2
(4) Prescaler mode register 0n (PRM0n)
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
PRM0n is the register that sets the TM0n count clock and TI00n and TI01n pin input valid edges.
Rewriting PRM0n is prohibited during operation (when TMC0n3 and TMC0n2 = other than 00).
PRM0n can be set by a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation clears PRM0n to 00H.
Cautions 1. Do not apply the following setting when setting the PRM0n1 and PRM0n0 bits to 11 (to specify
Remark n = 0:
n = 0, 1: 78K0/KE2 products whose flash memory is at least 48 KB, and 78K0/KF2 products
2. If the operation of the 16-bit timer/event counter 0n is enabled when the TI00n or TI01n pin is at
3. The valid edge of TI010 and timer output (TO00) cannot be used for the P01 pin at the same time,
the valid edge of the TI00n pin as a count clock).
• Clear & start mode entered by the TI00n pin valid edge
• Setting the TI00n pin as a capture trigger
high level and when the valid edge of the TI00n or TI01n pin is specified to be the rising edge or
both edges, the high level of the TI00n or TI01n pin is detected as a rising edge. Note this when
the TI00n or TI01n pin is pulled up. However, the rising edge is not detected when the timer
operation has been once stopped and then is enabled again.
and the valid edge of TI011 and timer output (TO01) cannot be used for the P06 pin at the same
time. Select either of the functions.
78K0/KE2 products whose flash memory is less than 32 KB, and 78K0/KB2, 78K0/KC2,
78K0/KD2 products
CHAPTER 7 16-BIT TIMER/EVENT COUNTERS 00 AND 01
285