HD64F2239FA16 Renesas Electronics America, HD64F2239FA16 Datasheet - Page 495

• Manufacturer Part Number: HD64F2239FA16
• Description: IC H8S MCU FLASH 384K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2239FA16

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Note: * Supported only by the H8S/2239 Group.
11.10
11.10.1 Module Stop Mode Setting
TPU operation can be disabled or enabled using the module stop control register. The initial
setting is for TPU operation to be halted. Register access is enabled by clearing module stop
mode. For details, refer to section 24, Power-Down Modes.
11.10.2 Input Clock Restrictions
The input clock pulse width must be at least 1.5 states in the case of single-edge detection, and at
least 2.5 states in the case of both-edge detection. The TPU will not operate properly with a
narrower pulse width.
In phase counting mode, the phase difference and overlap between the two input clocks must be at
least 1.5 states, and the pulse width must be at least 2.5 states. Figure 11.45 shows the input clock
conditions in phase counting mode.
Address
Status flag
Interrupt
request
signal
Note: * Supported only by the H8S/2239 Group.
Figure 11.44 Timing for Status Flag Clearing by DTC/DMAC* Activation
Usage Notes
φ
Source address
T
DTC/DMAC *
read cycle
1
T
2
Rev. 6.00 Mar. 18, 2010 Page 433 of 982
Section 11 16-Bit Timer Pulse Unit (TPU)
T
DTC/DMAC *
write cycle
Destination
1
address
T
2
REJ09B0054-0600