HD64F2239FA16 Renesas Electronics America, HD64F2239FA16 Datasheet - Page 306

• Manufacturer Part Number: HD64F2239FA16
• Description: IC H8S MCU FLASH 384K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of HD64F2239FA16

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 8 DMA Controller (DMAC)
8.5.5
DMAC supports the dual address mode, in which two different cycles are used for reading and
writing, and the single address mode, in which a single cycle is used for both reading and writing.
In dual address mode, the source address and the destination address are specified respectively for
transferring data.
In single address mode, data is transferred between the external space, in which the transfer source
or transfer destination is specified by the address, and the external device that is selected by
DACK strobe regardless of the address. Figure 8.9 shows the data bus in single address mode.
When the data bus is used for reading in single address mode, data is transferred from the external
memory to the external device and the DACK pin functions as the write strobe for the external
device. When the data bus is used for writing in single address mode, data is transferred from the
external device to the external memory and the DACK pin functions as the read strobe for the
external device. Since the direction for the external device cannot be controlled, chose one of
directions described above.
The setting of the bus controller for the external memory area controls the bus cycle in single
address mode. To the external device, DACK is output in synchronization with the address strobe.
For details on the bus cycle, see section 8.5.10, DMA Transfer (Single Address Mode) Bus
Cycles.
In single address mode, do not specify the internal area for the transfer address.
Rev. 6.00 Mar. 18, 2010 Page 244 of 982
REJ09B0054-0600
Single Address Mode
Figure 8.9 Data Bus in Single Address Mode
(High impedance)
This LSI
HWR, LWR
D15 to D0
A23 to A0
DACK
RD
Address bus
(Read)
(Write)
External
memory
External
device