Z8F4822AR020EC Zilog, Z8F4822AR020EC Datasheet - Page 108

• Manufacturer Part Number: Z8F4822AR020EC
• Description: IC ENCORE MCU FLASH 48K 64LQFP
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F4822AR020EC

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, POR, PWM, WDT
• Number Of I /o: 46
• Program Memory Size: 48KB (48K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: 269-3289

Table 47. Watchdog Timer Approximate Time-Out Delays
PS019921-0308
WDT Reload Value
FFFFFF
000004
Watchdog Timer Refresh
Watchdog Timer Time-Out Response
(Hex)
When first enabled, the Watchdog Timer is loaded with the value in the Watchdog Timer
Reload registers. The Watchdog Timer then counts down to
instruction is executed by the eZ8
downcounter to be reloaded with the WDT Reload value stored in the Watchdog Timer
Reload registers. Counting resumes following the reload operation.
When the Z8 Encore! XP
(through the On-Chip Debugger), the Watchdog Timer is continuously refreshed to pre-
vent spurious Watchdog Timer time-outs.
The Watchdog Timer times out when the counter reaches
Watchdog Timer generates either an interrupt or a Reset. The WDT_RES Option Bit
determines the time-out response of the Watchdog Timer. For information on
programming of the WDT_RES Option Bit, see
WDT Interrupt in Normal Operation
If configured to generate an interrupt when a time-out occurs, the Watchdog Timer issues
an interrupt request to the interrupt controller and sets the WDT status bit in the Watchdog
Timer Control register. If interrupts are enabled, the eZ8 CPU responds to the interrupt
request by fetching the Watchdog Timer interrupt vector and executing code from the
vector address. After time-out and interrupt generation, the Watchdog Timer counter rolls
over to its maximum value of
counter is not automatically returned to its Reload Value.
WDT Interrupt in STOP Mode
If configured to generate an interrupt when a time-out occurs and the Z8 Encore! XP
F64XX Series devices are in STOP mode, the Watchdog Timer automatically initiates a
Stop Mode Recovery and generates an interrupt request. Both the WDT status bit and the
STOP bit in the Watchdog Timer Control register are set to 1 following WDT time-out in
WDT Reload Value
16,777,215
(Decimal)
4
®
F64XX Series devices are operating in DEBUG Mode
FFFFFH
™
(with 10 kHz typical WDT oscillator frequency)
CPU. Execution of the WDT instruction causes the
and continues counting. The Watchdog Timer
1677.5 s
Typical
400 µs
Approximate Time-Out Delay
Option Bits
Z8 Encore! XP
000000H
on page 191.
000000H
Description
Maximum time-out delay
Product Specification
Minimum time-out delay
. A time-out of the
unless a WDT
®
F64XX Series
Watchdog Timer
94