HD64F3664FPV Renesas Electronics America, HD64F3664FPV Datasheet - Page 121

• Manufacturer Part Number: HD64F3664FPV
• Description: IC H8/3664 MCU FLASH 32K 64LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3664FPV

• Core Size: 16-Bit
• Program Memory Size: 32KB (32K x 8)
• Oscillator Type: External
• Core Processor: H8/300H
• Speed: 16MHz
• Connectivity: I²C, SCI
• Peripherals: PWM, WDT
• Number Of I /o: 29
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-LQFP
• No. Of I/o's: 29
• Ram Memory Size: 2KB
• Cpu Speed: 16MHz
• No. Of Timers: 4
• Digital Ic Case Style: LQFP
• Supply Voltage: RoHS Compliant
• Controller Family/series: H8/300H
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7.2.4
FLPWCR enables or disables a transition to the flash memory power-down mode when the LSI
switches to subactive mode. There are two modes: mode in which operation of the power supply
circuit of flash memory is partly halted in power-down mode and flash memory can be read, and
mode in which even if a transition is made to subactive mode, operation of the power supply
circuit of flash memory is retained and flash memory can be read.
7.2.5
Bit 7 (FLSHE) in FENR enables or disables the CPU access to the flash memory control registers,
FLMCR1, FLMCR2, EBR1, and FLPWCR.
7.3
There are two modes for programming/erasing of the flash memory; boot mode, which enables on-
board programming/erasing, and programmer mode, in which programming/erasing is performed
with a PROM programmer. On-board programming/erasing can also be performed in user
program mode. At reset-start in reset mode, the series of HD64F3664 changes to a mode
depending on the TEST pin settings, NMI pin settings, and input level of each port, as shown in
table 7.1. The input level of each pin must be defined four states before the reset ends.
Bit
7
6 to 0 —
Bit
7
6 to 0 —
Bit Name Initial Value
PDWND
Bit Name Initial Value
FLSHE
Flash Memory Power Control Register (FLPWCR)
Flash Memory Enable Register (FENR)
On-Board Programming Modes
0
All 0
0
All 0
R/W
R/W
—
R/W
R/W
—
Description
Power-Down Disable
When this bit is 0 and a transition is made to subactive
mode, the flash memory enters the power-down mode.
When this bit is 1, the flash memory remains in the
normal mode even after a transition is made to subactive
mode.
Reserved
These bits are always read as 0.
Description
Flash Memory Control Register Enable
Flash memory control registers can be accessed when
this bit is set to 1. Flash memory control registers cannot
be accessed when this bit is set to 0.
Reserved
These bits are always read as 0.
Rev. 5.00, 03/04, page 93 of 388