AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 52

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
AE-ISP-U1 connection for the TI MSP430F13x/14x devices in the BSL Mode
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
Isolating resistors:
Purpose of the R1..R4 resistors is to isolate the programmed chip from rest of target system.
Recommended value of resistors R1.. R4 is 2k or more. You can also use jumpers instead of the
resistors.
ISP characteristics:
1. Programmer's output capability:
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 MSP430 with TEST pin
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
2
3
4
5
6
7
8
9
RST/NMI
TEST
GND
VCC
P1.1
P2.2
-
-
-
-
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the target
power circuitry should not exceed 50 uF.
Page 52 of 56
8/19/2010