AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 16

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
AE-ISP-U1 connection for the Cypress CY8C2xxxx devices
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
1. Programmer's output capability:
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 Target Device ATtinyXX in High-Voltage Mode
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
ChipProg+
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the
target power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or
external power supply. In this case the power
output from the programmer should not be
connected with the target. The target system
should be tolerant to applying logical signals with
the voltage levels exceeding the voltages on the
target.
GND
PB1
PB2
PB5
PB3
PB0
Vcc
-
-
-
Page 16 of 56
8/19/2010