AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 49

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
Table of connections of the adapter output socket to the device pins:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
Isolating resistors:
Purpose of the R1..R6 resistors is to isolate the programmed chip from rest of target system.
Recommended value of resistors R1.. R6 is 2k or more. You can also use jumpers instead of the
resistors.
ISP characteristics:
1. Programmer's output capability:
2. The cable length should be less then one foot.
Adapter Output connector,
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
BH-10
1
3
Target Device M45xxx 8 pins
package
4
6
Powering the target device:
There are two alternative options
for powering the targets:
1. The target gets power from the
programmer (Vdd). This is
possible only if the target does not
consume too much energy. A
capacity of the target power
circuitry should not exceed 50 uF.
2. The target gets power from a
built-in or external power supply.
In this case the power output from
the programmer should not be
connected with the target. The
target system should be tolerant to
applying logical signals with the
voltage levels exceeding the
voltages on the target.
NOTE! It is strictly prohibited to
power the target from both the
programmer and built-in or
external power supply
simultaneously.
Target Device M45xxx 16 pins
package
10
16
Page 49 of 56
8/19/2010