AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 51

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
AE-ISP-U1 connection for the TI MSP430 devices in the BSL Mode with the TEST pin
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 Target Device STM32Fxxx
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
UART0.TXD
UART0.RXD
BOOT0
BOOT1
RESET
Vdd
Vss
-
-
-
Powering the target device:
There are two alternative options for powering the
targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does not
consume too much energy. A capacity of the target
power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or external
power supply. In this case the power output from
the programmer should not be connected with the
target. The target system should be tolerant to
applying logical signals with the voltage levels
exceeding the voltages on the target.
NOTE! It is strictly prohibited to power the target
from both the programmer and built-in or external
power supply simultaneously.
Page 51 of 56
8/19/2010