AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 19

ADAPTER 28-DIP TO BH-10

AE-ISP-U1

Manufacturer Part Number
AE-ISP-U1
Description
ADAPTER 28-DIP TO BH-10
Manufacturer
Phyton Inc
Datasheet

Specifications of AE-ISP-U1

Module/board Type
Adapter DIP28/BH-10
For Use With/related Products
ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
For Use With
CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
AE-ISP-U1
Recommended connection:
Table of connections of the adapter output socket to the device pins:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
Isolating resistors:
Purpose of the R1..R6 resistors is to isolate the programmed chip from rest of target system.
Recommended value of resistors R1..R6 is 2k or more. You can also use jumpers instead of the
resistors.
ISP characteristics:
1. Programmer's output capability:
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 Target Device DS89C4x0
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
10
1
3
5
7
9
8
6
4
40
11
31
20
19
10
9
-
-
Powering the target device:
There are two alternative options for
powering the targets:
1. The target gets power from the
programmer (Vdd). This is possible only if
the target does not consume too much
energy. A capacity of the target power
circuitry should not exceed 50 uF.
2. The target gets power from a built-in or
external power supply. In this case the
power output from the programmer should
not be connected with the target. The target
system should be tolerant to applying
logical signals with the voltage levels
exceeding the voltages on the target.
NOTE! It is strictly prohibited to power the
target from both the programmer and built-
in or external power supply simultaneously.
Page 19 of 56
8/19/2010

Related parts for AE-ISP-U1