DC9S08QE32 Freescale Semiconductor, DC9S08QE32 Datasheet - Page 37

• Manufacturer Part Number: DC9S08QE32
• Description: DAUGHTER CARD FOR DEMO9S
• Manufacturer: Freescale Semiconductor

Specifications of DC9S08QE32

• Accessory Type: Daughter Card
• Processor To Be Evaluated: MC9S08QE32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: Flexis - S08QE
• Rohs Compliant: Yes
• For Use With/related Products: DEMO9S
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.3.2
10
10.1
DEMO9S08QE32 User Manual
TROUBLESHOOTING
DEMO9S08QE32 Is Undetected
Software
The Cyclone PRO comes with intuitive configuration software and interactive
programming software, as well as easy to use automated control software.
The Cyclone PRO also functions as a full-featured debug interface, and is
supported by Freescale’s CodeWarrior as well as development software from
P&E.
P&E’s Cyclone PRO is also available bundled with additional software as part
of various Development Packages. In addition to the Cyclone PRO, these
Development Packages include in-circuit debugging software, flash
programming software, a Windows IDE, and register file editor.
Q: The connection assistant indicates that my DEMO9S08QE32 is
undetected even though I have connected the hardware to my USB port.
What should I do?
A: The connection assistant, which displays in either Codewarrior or P&E’s
development software, is a dialog which allows the user to connect to the
DEMO9S08QE32 hardware. If this dialog indicates that the DEMO9S08QE32
hardware is not connected to the PC, the first step is to make sure that the
DEMO9S08QE32 hardware is connected to the PC via a USB 2.0 high-speed
cable. If it is connected, unplug and then plug in the USB cable on the
DEMO9S08QE32 board and click refresh in the connection assistant. If the
hardware still does not show up, try the following remedies:
(A) Re-Enable the USB driver
If you connected the DEMO9S08QE32 interface prior to installing P&E’s
Embedded Multilink drivers, Windows will not have been able to find the
appropriate driver and may have disabled the device. The DEMO9S08QE32
board shows up in Window’s device manager as a “P&E Multilink,” since it
contains P&E’s Embedded Multilink circuitry. If you unplug and then plug in
the device, Windows will automatically disable it even if you have installed the
drivers. To force windows to try to load the driver again, perform the following
steps while the DEMO9S08QE32 interface is connected to the computer:
1. Open the Control Panel (Start Button->Settings->Control Panel)
33