AC244006 Microchip Technology, AC244006 Datasheet - Page 38

• Manufacturer Part Number: AC244006
• Description: KIT MPLAB REAL ICE TRACE
• Manufacturer: Microchip Technology

Specifications of AC244006

• Accessory Type: Interface Board
• Features: Instruction Trace Capability, Polarized Interface
• For Use With: PIC32MX Plug-in Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: PIC32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS51616A-page 34
®
5.7.2.2
Set up a data memory breakpoint here.
TABLE 5-4:
5.7.3
The stopwatch allows timing from one breakpoint/trigger condition to the next.
TABLE 5-5:
5.7.4
Select a condition where the program will always break:
• Break on Watchdog Timer – Break every time the watchdog timer times out. Make
• Break on SLEEP instruction – Break when a SLEEP instruction is encountered in
Address
Breakpoint Type
Pass Count
Start Condition
Stop Condition
Reset stopwatch on run
sure the Watchdog Timer is enabled in the Configuration bits.
the program.
Control
Control
DATA MEMORY TAB
Stopwatch Dialog
Event Breakpoints Dialog
™
DATA MEMORY BREAKPOINT
STOPWATCH SETUP
Location of breakpoint in hex
The type of data memory breakpoint. See the device data sheet for
more information on X Bus reads/writes.
X Bus Read
X Bus Read Specific Byte
address for the specific byte value in “Specific Value”
X Bus Read Specific Word
address for the specific word value in “Specific Value”
X Bus Write
X Bus Write Specific Byte
address for the specific byte value in “Specific Value”
X Bus Write Specific Word
address for the specific word value in “Specific Value”
Break on pass count condition.
Always break
Break occurs Count instructions after Event
instructions before breaking after event specified in “Breakpoint
type”
Event must occur Count times
“Breakpoint type” occurs Count (0-255) times
Click Select Start Condition to choose an available breakpoint or
trigger condition to start the stopwatch. Available breakpoints/trig-
gers are those previously added to the breakpoint dialog.
Click None to clear the start condition.
To halt the program run on this condition, check the check box next
to “Start condition will cause the target device to halt”.
Click Select Stop Condition to choose an available breakpoint or
trigger condition to stop the stopwatch. Available breakpoints/trig-
gers are those previously added to the breakpoint dialog.
Click None to clear the stop condition.
To halt the program run on this condition, check the check box next
to “Stop condition will cause the target device to halt”.
Reset the stopwatch values to zero every time the program is run.
–
–
–
break on an X bus write of above address
break on an X bus read of above address
always break as specified in “Breakpoint type”
–
–
–
–
break on an X bus write of above
Function
break on an X bus read of above
Function
break on an X bus write of above
break on an X bus read of above
–
break only after event specified in
© 2006 Microchip Technology Inc.
–
wait Count (0-255)