20-101-0542 Rabbit Semiconductor, 20-101-0542 Datasheet - Page 25

• Manufacturer Part Number: 20-101-0542
• Description: CABLE 1.27MM FOR RCM3200
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0542

• Accessory Type: Programming Cable
• Product: Microcontroller Accessories
• For Use With/related Products: Rabbit 3000-based products, except RCM30/3100, LP3500
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-0542; 316-1180

3.1 Introduction
To help familiarize you with the RCM3200 modules, Dynamic C includes several sample
programs. Loading, executing and studying these programs will give you a solid hands-on
overview of the RCM3200’s capabilities, as well as a quick start using Dynamic C as an
application development tool.
Complete information on Dynamic C is provided in the Dynamic C User’s Manual.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3200 module must be plugged in to the Prototyping Board as described in
2. Dynamic C must be installed and running on your PC.
3. The RCM3200 module must be connected to your PC through the serial programming
4. Power must be applied to the RCM3200 through the Prototyping Board.
Refer to Chapter 2, “Hardware Setup,” if you need further information on these steps.
If you are using an RCM3200 or RCM3220, remember to allow the compiler to run the
application in the program execution SRAM by selecting
in RAM
To run a sample program, open it with the
pile and run the program.
Complete information on Dynamic C is provided in the Dynamic C User’s Manual.
User’s Manual
Chapter 2, “Hardware Setup.”
cable.
To develop and debug programs for the RCM3200 (and for all
other Rabbit hardware), you must install and use Dynamic C.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
from the Dynamic C
programming language. If you do not, see the introductory pages of the Dynamic C
User’s Manual for a suggested reading list.
3. R
UNNING
Options > Project Options > Compiler
File
S
menu, then press function key
AMPLE
Code and BIOS in Flash, Run
P
ROGRAMS
menu.
F9
to com-
19