ATTIny13-12PI ATMEL Corporation, ATTIny13-12PI Datasheet - Page 105

no-image

ATTIny13-12PI

Manufacturer Part Number
ATTIny13-12PI
Description
8-bit AVR Microcontroller with 1K Bytes In-System Programmable Flash
Manufacturer
ATMEL Corporation
Datasheet
Data Polling Flash
Data Polling EEPROM
2535B–AVR–01/04
When a page is being programmed into the Flash, reading an address location within
the page being programmed will give the value 0xFF. At the time the device is ready for
a new page, the programmed value will read correctly. This is used to determine when
the next page can be written. Note that the entire page is written simultaneously and any
address within the page can be used for polling. Data polling of the Flash will not work
for the value 0xFF, so when programming this value, the user will have to wait for at
least t
0xFF in all locations, programming of addresses that are meant to contain 0xFF, can be
skipped. See Table 49 for t
When a new byte has been written and is being programmed into EEPROM, reading the
address location being programmed will give the value 0xFF. At the time the device is
ready for a new byte, the programmed value will read correctly. This is used to deter-
mine when the next byte can be written. This will not work for the value 0xFF, but the
user should have the following in mind: As a chip-erased device contains 0xFF in all
locations, programming of addresses that are meant to contain 0xFF, can be skipped.
This does not apply if the EEPROM is re-programmed without chip erasing the device.
In this case, data polling cannot be used for the value 0xFF, and the user will have to
wait at least t
value.
Table 49. Minimum Wait Delay Before Writing the Next Flash or EEPROM Location
Figure 54. Serial Programming Waveforms
Symbol
t
t
t
t
WD_FLASH
WD_EEPROM
WD_ERASE
WD_FUSE
SERIAL DATA OUTPUT
SERIAL CLOCK INPUT
SERIAL DATA INPUT
WD_FLASH
SAMPLE
WD_EEPROM
(MOSI)
(MISO)
(SCK)
before programming the next page. As a chip-erased device contains
before programming the next byte. See Table 49 for t
MSB
MSB
WD_FLASH
value.
Minimum Wait Delay
4.5 ms
4.0 ms
4.0 ms
4.5 ms
ATtiny13
LSB
LSB
WD_EEPROM
105

Related parts for ATTIny13-12PI