P82B96TD,118 NXP Semiconductors, P82B96TD,118 Datasheet - Page 28

• Manufacturer Part Number: P82B96TD,118
• Description: IC I2C BUS BUFFER DUAL 8-SOIC
• Manufacturer: NXP Semiconductors
• Type: Bufferr

Specifications of P82B96TD,118

• Package / Case: 8-SOIC (3.9mm Width)
• Tx/rx Type: I²C Logic
• Delay Time: 5.0ns
• Capacitance - Input: 7pF
• Voltage - Supply: 2 V ~ 15 V
• Current - Supply: 900µA
• Mounting Type: Surface Mount
• Number Of Channels Per Chip: Dual
• Supply Voltage (max): 15 V
• Supply Voltage (min): 2 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Logic Type: Bidirectional Bus Buffer
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: OM6285 - EVAL BOARD I2C-2002-1A568-4002 - DEMO BOARD I2C
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-1009-2; 935262295118; P82B96TD-T

NXP Semiconductors
13. Soldering of through-hole mount packages
P82B96_8
Product data sheet
13.1 Introduction to soldering through-hole mount packages
13.2 Soldering by dipping or by solder wave
13.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 28. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
Rev. 08 — 10 November 2009
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
Dual bidirectional bus buffer
temperature
peak
stg(max)
© NXP B.V. 2009. All rights reserved.
P82B96
001aac844
). If the
time
28 of 32