20-101-1306 Rabbit Semiconductor, 20-101-1306 Datasheet - Page 33

• Manufacturer Part Number: 20-101-1306
• Description: CORE MODULE RCM5750
• Manufacturer: Rabbit Semiconductor
• Type: Serial to Ethernetr

Specifications of 20-101-1306

• Module/board Type: MPU Core Module
• Number Of I/os: 32
• Ethernet Connection Type: 10/100 Base-T
• Memory Type: Flash
• Operating Voltage: 3.3 V
• Operating Current: 70 mA
• Operating Temperature Range: - 40 C to + 85 C
• Board Size: 30 mm x 51 mm x 3 mm
• Product: Modules
• For Use With/related Products: RCM5750
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1183

4.1.1 Memory I/O Interface
The Rabbit 5000 address lines (A0–A19) and data lines (D0–D7) are routed to the onboard flash
memory chip. I/O write (/IOWR) and I/O read (/IORD) are available for interfacing to external
devices.
Parallel Port A can also be used as an external I/O data bus to isolate external I/O from the main
data bus. Parallel Port B pins PB2–PB7 can also be used as an external address bus.
When using the external I/O bus for either Ethernet or the LCD/keypad module on the Prototyp-
ing Board or for any other reason, you must add the following line at the beginning of your pro-
gram.
#define PORTA_AUX_IO
// required to enable external I/O bus
Selected pins on Parallel Ports D and E as specified in Table 4-3 may be used for input capture,
quadrature decoder, DMA, and pulse-width modulator purposes.
4.1.2 Other Inputs and Outputs
The status, /RESET_IN, and SMODE I/O are normally associated with the programming port.
Since the status pin is not used by the system once a program has been downloaded and is run-
ning, the status pin can then be used as a general-purpose CMOS output. The programming port is
described in more detail in Section 4.2.3.
/RESET_IN is an external input used to reset the Rabbit 5000/6000 microprocessor and the Mini-
Core memory. /RESET is an output from the reset circuitry that can be used to reset other periph-
eral devices.
The two SMODE pins, SMODE0 and SMODE1, are tied together, and may be used as a special
input when the MiniCore is operating in the Run Mode. The logic state of these two pins deter-
mines the startup procedure after a reset.
rabbit.com
MiniCore RCM5700/RCM6700 User’s Manual
33