DLP-RF2 DLP Design Inc, DLP-RF2 Datasheet - Page 11

• Manufacturer Part Number: DLP-RF2
• Description: Zigbee / 802.15.4 Modules & Development Tools USE 626-DLP-RF2-Z
• Manufacturer: DLP Design Inc

Specifications of DLP-RF2

• Wireless Frequency: 2.4 GHz
• Interface Type: 2 Wire Serial
• Output Power: 1 mW
• For Use With/related Products: MC13193, MC9S08GT60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.3 FCC/IC Requirements for Modular Approval
Any changes or modifications to the DLP-RF2-Z’s printed circuit board could void the user’s
authority to operate the equipment.
6.3.1 Warnings
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesirable operation.
This device is intended for use under the following conditions:
1. The transmitter module may not be co-located with any other transmitter or antenna.
2. The module is approved using the FCC “unlicensed modular transmitter approval” method.
As long as these two conditions are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end product for any additional
compliance measures necessitated by the installation of this module (i.e. digital device
emissions, PC peripheral requirements, etc.).
Note: In the event that these conditions cannot be met (i.e. co-location with another
transmitter), then the FCC authorization is no longer valid and the corresponding FCC ID may
not be used on the final product. Under these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC authorization.
6.3.2 OEM Product Labeling
The final end product must be labeled in a visible area with the following text:
“Contains TX FCC ID: SX9000RF2”
6.3.3 RF Exposure
Note: In order to comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
6.3.4 Additional Information for OEM Integrators
The end user should NOT be provided with any instructions on how to remove or install the
DLP-RF2-Z.
7.0 Disclaimer
DLP-RF2-Z  DLP Design, Inc.
11
Rev 1.8 (November 2005)