ZGP32302010ZDH Zilog, ZGP32302010ZDH Datasheet - Page 4

• Manufacturer Part Number: ZGP32302010ZDH
• Description: ADAPTER ICE Z8 GP ZGP323 20SSOP
• Manufacturer: Zilog

Specifications of ZGP32302010ZDH

• Convert From (adapter End): 20-Pin DIP
• Convert To (adapter End): 20-Pin SSOP
• For Use With/related Products: Z8 GP ZGP323
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-3738

Page 4
Z8 GP™ ZGP323 In-Circuit Emulator and Development Platform
User Manual
Connecting the Z8 GP ICE to the Target POD
Once you have installed the appropriate target POD (and converter, if required) onto the
target development board, connect the Z8 GP ICE to the target POD as follows:
•
•
Connecting the Z8 GP ICE to the OTP Programming Module (Optional)
After developing and debugging your software, use the following instructions to connect
the Z8 GP ICE to the OTP programming module so you can burn your code onto chips.
1. Connect the 40-circuit ribbon cable from the Z8 GP ICE OTP Programming connector
2. The 40-PDIP ZIF socket on the OTP programming module is designed to accept 40-
Once you have installed the OTP chip into the ZIF socket (or programming adapter), you
are ready to program the chip using the instructions in “OTP Programming” on page 18.
Connecting the Z8 GP ICE to a PC
1. Connect a CAT-5 crossover cable from the PC to the Ethernet port on the Z8 GP ICE.
Install the Hardware
Note:
40-PDIP target POD:
– Connect the 16-circuit cable from P17 on the emulator to P17 on the 40-PDIP tar-
– Connect the 34-circuit cable from P16 on the emulator to P16 on the 40-PDIP target
20-PDIP and 28-PDIP target PODs: Connect the 34-circuit cable from P16 on the
emulator to P16 on the target POD. (Emulator connector P17 is not used.)
to connector P1 on the OTP programming module.
PDIP OTP chips. The OTP programming adapters (see Table 4 on page 24) allow you
to adapt the ZIF socket to accept 20-SOIC, 20-SSOP, 20-PDIP, 28-SOIC, 28-SSOP,
28-PDIP, and 48-SSOP chip packages.
See Figure 2.
get POD.
POD.
If you prefer, you can connect the emulator to an Ethernet hub using a stan-
dard CAT-5 patch cable.
UM019302-0407