ST7MDT2-DVP2/US STMicroelectronics, ST7MDT2-DVP2/US Datasheet - Page 67

• Manufacturer Part Number: ST7MDT2-DVP2/US
• Description: KIT DEVELOPMENT ST7
• Manufacturer: STMicroelectronics
• Series: ST7-DVP2r
• Type: Microcontrollerr

Specifications of ST7MDT2-DVP2/US

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72254, ST72215, ST72216, ST72104, ST72225, ST72213, ST72212, ST72101
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST7MDT2-DVP2 User Manual
APPENDIX A: EMC CONFORMITY AND SAFETY REQUIREMENTS
This development board respects the EMC requirements of the European
guideline 89/336/EEC under the following conditions:
•
•
•
•
•
•
•
•
•
Any tester, equipment, or tool used at any production step or for any
manipulation of semi-conductor devices have its shield connected to ground.
All ferrites provided with the development kit must be attached as described in
the hardware installation instructions of the relevant user manual(s).
Your development board must be placed on a conductive table top, made of
steel or clean aluminumor covered by an antistatic surface (superficial
resistivity equal to or higher than 0.5 M /cm
cable(conductive cable from protected equipment to ground isolated through a
1 M
All manipulation of finished goods be made at such a grounded worktable.
The worktable must be free of all non-antistatic plastic objects.
An antistatic floor covering grounded through a conductive ground cable (with
serial resistor between 0.9 and 1.5 M ) should be used.
It is recommended that you wear an antistatic wrist or ankle strap, connected to
the antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the
powered-on development board, you
worktable.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any
manipulation of parts.
resistor placed in series).
Appendix A: EMC Conformity and Safety Requirements
touch the surface of the grounded
2
), grounded through a ground
67/82