M3A-2114G62 Renesas Electronics America, M3A-2114G62 Datasheet - Page 29

• Manufacturer Part Number: M3A-2114G62
• Description: DEV M32171 (MCU SOCKET TYPE) STA
• Manufacturer: Renesas Electronics America
• Type: MCUr

Specifications of M3A-2114G62

• Contents: Board, Serial Cable, C Compiler, Debugger, Programmer and Documentation
• For Use With/related Products: M32171
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5
Jumper Name
JP1
JP2
JP3
5.1.2 M3A-2114 Evaluation Board Power Supply and Settings
The following shows how to set the M3A-2114 Evaluation Board.
Use a 5V DC power supply to feed power to the M3A-2114 Evaluation Board.
Use included 5V power supply cable to connect the 5V DC power supply and CN2 connector included with the
M3A-2114 Evaluation Board. The method for connecting them is shown in Figure 5.1-2.
5.1.3 Connecting M3A-2114 Evaluation Board and M32100T-EZ-E
Use included 10-pin flat cable and M3A-2191 to connect M32100T-EZ-E and CN8 connector included with the
M3A-2114 Evaluation Board.
The method for connecting M32100T-EZ-E and the M3A-2114 Evaluation Board is shown in Figure 5.1-3.
5.1.4 System Power-on Sequence when M3A-2114G52A/ G62A/ G72A in use
- When turning on power, turn on M32100T-EZ-E first and then the M3A-2114 Evaluation Board.
- When turning off power, turn off the M3A-2114 Evaluation Board first and then M32100T-EZ-E.
- When turning on power again after turning off power, wait for 10 seconds.
- Power to M32100T-EZ-E can be fed from USB cable.
Note: Unless the Starter Kit is powered on this sequence, the kit may operate erratically or break down.
SDI I/F
Jumper Settings
Shorted between 1-2
Shorted between 1-2
Shorted between 1-2
Figure 5.1-3 Connecting M3A-2114 Evaluation Board and M32100T-EZ-E
Figure 5.1-2 Feeding Power to the M3A-2114 Evaluation Board
M3A-2114 evaluation board
LED1
M32100T-EZ-E
Table 5.1-1 Jumper Settings before Shipment
JP3
JP2
10 pin flat cable
JP1
Remarks
Uses power from CN2 connector to AVCC power supply
Uses power from CN2 connector to the voltage regulator
Uses power from the voltage regulator to VCCI power supply
CN2
M3A-2191 connector pitch converter
4.75 - 5.25V DC power supply
M3A-2114 evaluation board
CN8
M3A-2114 User’s Manual (27/68)
Hardware Setup