101-1017 Rabbit Semiconductor, 101-1017 Datasheet - Page 131

• Manufacturer Part Number: 101-1017
• Description: KIT DEV POWERCORE 3800 INT'L
• Manufacturer: Rabbit Semiconductor
• Series: PowerCore FLEXr
• Type: MPU Moduler

Specifications of 101-1017

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: PowerCore 38xx
• Interface Type: Ethernet
• For Use With/related Products: RCM3800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

B.1.1 Prototyping Board Features
•
•
•
•
•
•
•
•
•
•
•
User’s Manual
Power Connection
totyping Board by the PowerCore module. These voltages can be used to power cus-
tomer-installed parts in the prototyping area.
Power LEDs
is being supplied to the Prototyping Board from the PowerCore module.
Prototyping Area
of through-hole components. +5 V, +3.45 V, and Ground buses run along one edge of
this area. Several areas for surface-mount devices are also available. Each SMT pad is
connected to a hole designed to accept a 30 AWG solid wire.
Reset Switch
PowerCore module’s
system.
I/O Switches and LEDs
nected to the PC3 and PG4 pins of the PowerCore module and may be read as inputs by
sample applications.
Two user LEDs (DS5–DS6) are connected to I/O pins PD5 and PC2 of the PowerCore
module.
LCD/Keypad Module
in directly to headers LCD1:JA, LCD1:JB, and LCD1:JC. The signals on headers
LCD1:JB and LCD1:JC will be available only if the LCD/keypad module is plugged in
to header LCD1:JA. Appendix C provides complete information for mounting and
using the LCD/keypad module.
Module Extension Header
J4. Developers can solder wires directly into the appropriate holes, or, for more flexible
development, a 2 × 25 header strip with a 0.1" pitch can be soldered into place. See
Figure B-3 for the header pinouts.
Digital I/O
digital inputs are available at header location J4. See Figure B-3 for the header pinouts.
Triacs
for general-purpose AC switching applications such as electrovalves, pumps, door
locks, small lamp control, and fan-speed control. Their outputs are available on header
J2. Miniature incandescent lamps may also be installed on the Prototyping Board to
observe the triac operation.
RS-232
Prototyping Board at header J1.
RabbitNet Port
eral cards to be used with the PowerCore Prototyping Board.
—Two Z0107MN triacs are installed on the Prototyping Board, and can be used
—Two 3-wire serial ports or one 5-wire RS-232 serial port are available on the
—Four digital outputs and a +K connection are available on header J2. Two
—The two power LEDs at DS3 and DS4 light whenever +3.45 V and + 5 V
—A momentary-contact, normally open switch is connected directly to the
—One RS-422 RabbitNet port is available to allow RabbitNet periph-
—A generous prototyping area has been provided for the installation
—+5 V, +3.45 V, and AC1_DCIN voltages are supplied to the Pro-
/RESET_IN
—Rabbit Semiconductor’s LCD/keypad module may be plugged
—Two momentary-contact, normally open switches are con-
—The PowerCore module’s pin set is duplicated at header
pin. Pressing the switch forces a hardware reset of the
123