M5211DEMO Freescale Semiconductor, M5211DEMO Datasheet - Page 9

• Manufacturer Part Number: M5211DEMO
• Description: KIT DEMO FOR MCF5211
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MPUr

Specifications of M5211DEMO

• Contents: SBC, Cables and Software
• Processor To Be Evaluated: MCF521x
• Data Bus Width: 12 bit
• Interface Type: RS-232, USB
• Operating Supply Voltage: 9 V
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire
• Core Sub-architecture: Coldfire V2
• Silicon Core Number: MCF52
• Silicon Family Name: MCF521x
• Rohs Compliant: Yes
• For Use With/related Products: MCF5211, MCF5212, MCF5213
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7.1
7.1.1
The PWR power jack, shown in
applied at this connector should range between +5 V and +20 V.
7.1.2
The BATT terminal block, shown in
to the VDD voltage rail. Caution must be used when using this input since input protection is not applied.
Use of this input requires a regulated +3.3 V voltage source.
7.1.3
See the schematic for details on using this connection to supply power to the board or source power from
the board. Use of this input requires a regulated +3.3 V voltage source.
7.2
The VDD LED indicates the state of power applied to the development board. This LED is on when power
is applied to the board. If no power is applied or the OFF/ON switch is in the OFF position, this LED be
off. The VDD LED is located after the OFF/ON switch and will indicate the state of the switch if the board
is powered from the on-board regulator, the USB circuit, or the BATT terminal block input.
Freescale Semiconductor
Power Input
VDD LED
Power (PWR) Jack
Terminal (BATT) Block
Connector J1
Do not overdrive the J1 or BATT inputs as damage to the board may result.
PWR
Demonstration Board for Freescale MCF5211, Rev. 1
Figure
Figure
Figure 4. BATT Terminal Block
3, consists of a 2.1 mm, center-positive, barrel connector. Voltage
2.0 mm–2.1 mm, center-positive, +V input
Applied voltage: +5 V – +20 V
Accepts wire size 28 AWG – 16 AWG
Applied voltage must be +3.3 V.
Figure 3. PWR Jack
4, is a 3.5 mm, screw-type terminal block connected directly
CAUTION
Power
9