STEVAL-MKI062V2 STMicroelectronics, STEVAL-MKI062V2 Datasheet - Page 34

BOARD EVAL FOR MEMS SENSORS

STEVAL-MKI062V2

Manufacturer Part Number
STEVAL-MKI062V2
Description
BOARD EVAL FOR MEMS SENSORS
Manufacturer
STMicroelectronics
Series
iNEMOr

Specifications of STEVAL-MKI062V2

Design Resources
STEVAL-MKI062V2 Gerber Files STEVAL-MKI062V2 Schematic STEVAL-MKI062V2 Bill of Materials
Sensor Type
Accelerometer, Gyroscope, Magnetometer, Pressure, Temperature
Sensing Range
±2g,4g,8g; 300 ~ 1100mbar; 300°/sec; -55 ~125°C
Interface
I²C, USB
Sensitivity
Multiple
Voltage - Supply
5V, USB
Embedded
Yes, MCU, 32-Bit
Utilized Ic / Part
LPR430AL, LY330ALH, LSM303DLH, LPS001DL, STM32F103RE, STLM75
Interface Type
USB, CAN, I2C
Maximum Operating Temperature
+ 125 C
Minimum Operating Temperature
- 55 C
Silicon Manufacturer
STMicroelectronics
Kit Application Type
Sensor
Application Sub Type
MEMS Device
Silicon Family Name
INEMO
Kit Contents
MicroSD Card Slot, COM Connector, Reset Button,
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
STM32F103RE
Other names
497-10508

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
STEVAL-MKI062V2
Manufacturer:
STMicroelectronics
Quantity:
135
STM32-MEMS development kit
7.5.2
34/42
Figure 19. MEMS USB Reader Windows GUI application
STM32-MEMS LCD demonstration applications
The STM32-MEMS LCD demonstration applications read data from the MEMS sensor and
display it on the LCD mounted on the STM32 demonstration board. When a digital MEMS
with double-click detection is attached (for example, LIS302DL) the demonstration
applications utilize an interrupt generated by the MEMS and show a message on the LCD
when the double-click event occurs.
It is possible to use any of the compatible MEMS demonstration boards (see list in previous
section) without changing the firmware. However, do not forget to change the jumper
settings on the STM32-MEMS demonstration board if needed (for example, when changing
from an analog MEMS to a digital one).
Follow these steps to run the demonstration application.
1.
2.
3.
Mount the STM32-MEMS demonstration board onto the STM32 demonstration board
and mount the MEMS demonstration board onto the STM32-MEMS demonstration
board.
Correctly set-up the jumpers on the STM32-MEMS demonstration board. Do not forget
to position the JP10 jumper and set-up the board for use with the INT1 signal if needed.
Compile, flash and run the project corresponding to your STM32 demonstration board.
Doc ID 15703 Rev 1
UM0701