STEVAL-MKI062V2 STMicroelectronics, STEVAL-MKI062V2 Datasheet - Page 21
Manufacturer Part Number
BOARD EVAL FOR MEMS SENSORS
Specifications of STEVAL-MKI062V2
STEVAL-MKI062V2 Gerber Files STEVAL-MKI062V2 Schematic STEVAL-MKI062V2 Bill of Materials
Accelerometer, Gyroscope, Magnetometer, Pressure, Temperature
±2g,4g,8g; 300 ~ 1100mbar; 300°/sec; -55 ~125°C
Voltage - Supply
Yes, MCU, 32-Bit
Utilized Ic / Part
LPR430AL, LY330ALH, LSM303DLH, LPS001DL, STM32F103RE, STLM75
USB, CAN, I2C
Maximum Operating Temperature
+ 125 C
Minimum Operating Temperature
- 55 C
Kit Application Type
Application Sub Type
Silicon Family Name
MicroSD Card Slot, COM Connector, Reset Button,
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
This file provides constants containing the I
value related to several digital MEMS sensors (LIS302DL, LIS3LV02DL). It also defines
a type used to store data from the axis of a MEMS accelerometer.
This file provides constants for configuration and utilization of STM32 peripherals related to
the MEMS sensor attached to the STM32-MEMS demonstration board. The constants
correspond to pins and peripherals of the STM32 microcontroller connected to the MEMS
There are three sets of constants. Each set contains the same constants but for different
STM32 demonstration boards. To choose a particular set, one of the three #define
statements at the beginning of the file must be uncommented. The #define statements
For example, the correct definition to choose a set of constants for the ST STM3210B-EVAL
demonstration board is:
// #define STM3210E_EVAL
// #define STM3210B_SK_IAR
This file provides functions for configuration and utilization of STM32 peripherals related to
the MEMS sensor attached to the STM32-MEMS demonstration board.
MEMS Library functions reference
MEMS Library functions
lists the MEMS Library functions.
Sets-up all peripherals related to the analog MEMS.
Drives the FS pin of the analog MEMS.
Drives the PD pin of the analog MEMS.
Restarts the ADC and DMA.
Gets values of all MEMS axes.
Enables or disables EXTI for the Int1 interrupt signal.
Enables or disables EXTI for the Int2 interrupt signal.
Sets-up all peripherals related to the digital MEMS connected over the SPI.
Doc ID 15703 Rev 1
C address, register addresses and who_am_i
STM32-MEMS development kit