MULTIPHSPOL-RD Silicon Laboratories Inc, MULTIPHSPOL-RD Datasheet - Page 22

• Manufacturer Part Number: MULTIPHSPOL-RD
• Description: KIT REFERENCE DESIGN FOR SI825X
• Manufacturer: Silicon Laboratories Inc
• Type: Other Power Managementr

Specifications of MULTIPHSPOL-RD

• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 3.3V
• Current - Output: 40A
• Voltage - Input: 10 ~ 15V
• Regulator Topology: Buck
• Frequency - Switching: 391kHz
• Board Type: Fully Populated
• Utilized Ic / Part: SI8250, SI8251, SI8252
• Input Voltage: 10 V to 15 V
• Output Voltage: 3.3 V
• Interface Type: USB
• Product: Power Management Modules
• Supply Current: 10 A
• For Use With/related Products: Si8250
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1323

Si8250/1/2
In both cases, the bias supplies must be filtered using
low ESR/ESL capacitors placed close to the IC pins.
Thick copper traces should be connected to the bias
pins (V
reduce resistance and inductance. The copper routings
from the drivers to the FETs should be kept short and
wide, especially in very high frequency applications, to
reduce inductance of the traces so that the drive signals
can be kept clean. Connections between V
the output voltage must be kept as short as possible to
minimize inductance and parasitic ringing effects.
22
DD
, V
DDA
(C2D, C2CK)
Debug Pins
) and the ground pins (GND, GNDA) to
Si8250/1/2
Figure 12. Debug Interface Pin Protection Circuit
10
SENSE
and
Rev. 1.0
It is best to locate the Si8250/1/2 as close to the output
voltage terminal as possible and use a Kelvin
connection to reduce the difference in ground potential
between the Si8250/1/2 and the output voltage ground
return. Most applications will require access to the
debug pins. These pins are susceptible to damage from
electrostatic
recommended that the debug circuit interface use the
input protection circuitry shown in Figure 12.
10
discharge
CONNECTOR
(ESD).
DEBUG
It
is,
therefore,