EVL6564-100W STMicroelectronics, EVL6564-100W Datasheet - Page 18

• Manufacturer Part Number: EVL6564-100W
• Description: BOARD EVAL PFC FOR L6564D
• Manufacturer: STMicroelectronics
• Type: Power Factor Correctionr

Specifications of EVL6564-100W

• Main Purpose: AC/DC, Primary Side
• Outputs And Type: 1, Non-Isolated
• Power - Output: 100W
• Voltage - Output: 400V
• Voltage - Input: 90 ~ 265VAC
• Regulator Topology: Boost
• Frequency - Switching: 40kHz
• Board Type: Fully Populated
• Utilized Ic / Part: L6564
• Input Voltage: 90 V to 265 V
• Output Voltage: 400 V
• Dimensions: 90 mm x 83 mm
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Current - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: L6564
• Other names: 497-10164

Application information
6
6.1
18/33
Application information
Overvoltage protection
Normally, the voltage control loop keeps the output voltage Vo of the PFC pre-regulator
close to its nominal value, set by the ratio of the resistors R1 and R2 of the output divider. A
pin of the device (PFC_OK) has been dedicated to monitor the output voltage with a
separate resistor divider (R3 high, R4 low, see
the voltage at the pin reaches 2.5 V if the output voltage exceeds a preset value, usually
larger than the maximum Vo that can be expected.
Example: V
51 kΩ.
When this function is triggered, the gate drive activity is immediately stopped until the
voltage on the pin PFC_OK drops below 2.4 V. Notice that R1, R2, R3 and R4 can be
selected without any constraints. The unique criterion is that both dividers have to sink a
current from the output bus which needs to be significantly higher than the bias current of
both INV and PFC_OK pins.
Figure 27. Output voltage setting, OVP and FFP functions: internal block diagram
O
= 400 V, V
OX
= 434 V. Select: R3 = 8.8 MΩ; then: R4 = 8.8 MΩ ·2.5/(434-2.5) =
Doc ID 16202 Rev 2
Figure
27). This divider is selected so that
L6564