ADC08D1500DEV/NOPB National Semiconductor, ADC08D1500DEV/NOPB Datasheet - Page 17

• Manufacturer Part Number: ADC08D1500DEV/NOPB
• Description: BOARD DEV FOR ADC08D1500
• Manufacturer: National Semiconductor
• Series: PowerWise®r

Specifications of ADC08D1500DEV/NOPB

• Mfg Application Notes: Clocking High-Speed A/D Converters AppNote
• Number Of Adc's: 2
• Number Of Bits: 8
• Sampling Rate (per Second): 1.5G
• Data Interface: Serial
• Inputs Per Adc: 1 Differential
• Input Range: 870 mVpp
• Power (typ) @ Conditions: 1.8W @ 1.5GSPS
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: ADC08D1500
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ADC08D1500DEV

17
If the board has not been detected click the “Test” button under the Communication heading and the
development board should be found. If the communications fail, check that the USB drivers are installed
correctly, then disconnect and re-connect the USB cable. Finally restart the Wavevision 4 software See
Appendix B for more information.
9.2 Control Panel
Once the FPGA Firmware download has completed the development board Control Panel will
automatically be displayed as shown below.
The Following section describes the Function of the pull-down selection tabs in the left hand side of the
ADC08D1500DEV product Control Panel
Channel Selection
I – Displays the data captured from the I Channel Only after acquiring Samples
Q- Displays the data captured from the Q Channel Only after acquiring Samples
I and Q – Displays the data captured from I and Q channels in 2 windows after acquiring samples.
I/Q Interleaved – Displays the data captured from the I and Q channels interleaved in a single window,
after acquiring samples (Use when DES mode is enabled).
Temp Sensor
Displayed below the Channel Selection tab is the die temperature of both the FPGA and the ADC.