CDB5376 Cirrus Logic Inc, CDB5376 Datasheet - Page 20

• Manufacturer Part Number: CDB5376
• Description: EVALUATION BOARD FOR CS5376
• Manufacturer: Cirrus Logic Inc

Specifications of CDB5376

• Main Purpose: Seismic Evaluation System
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: CS3301A, CS3302A, CS4373A, CS5372A, CS5376A
• Primary Attributes: Quad Digital Filter
• Secondary Attributes: Graphical User Interface, SPI™ & USB Interfaces
• Processor To Be Evaluated: CS330x, CS4373A, CS537x
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 598-1778

6. POWER MODES
The CS5371A and CS5372A modulators have
three power modes. Normal operation, power
down with MCLK enabled, and power down
with MCLK disabled.
6.1 Normal Operation
With MCLK active and the PWDN pin driven
low, the CS5371A and CS5372A modulators
perform normal data acquisition. A differential
analog input signal is converted to an overs-
ampled 1-bit ΔΣ bit stream at 512 kHz. This ΔΣ
bit stream is then digitally filtered and decimat-
ed by the CS5376A device to a high-precision
24-bit output.
6.2 Power Down, MCLK Enabled
With MCLK active and the PWDN pin driven
high, the CS5371A and CS5372A modulators
are placed into a power-down state. During
20
NORMAL OPERATION
MCLK = ON
PWDN = 0
Figure 13. Power Mode Diagram
POWER DOWN
MCLK = OFF
PWDN = X
this power-down state the modulators are dis-
abled and all outputs are high impedance.
6.3 Power Down, MCLK Disabled
If MCLK is stopped, an internal loss-of-clock
detection circuit automatically places the
CS5371A and CS5372A into a power-down
state. This power-down state is independent of
the PWDN pin setting and is automatically in-
voked after approximately 40 μs without re-
ceiving an incoming MCLK edge.
During this power-down state, the modulators
are disabled and all outputs are high imped-
ance. When used with the CS5376A digital fil-
ter, the CS5371A and CS5372A are in this
power-down state immediately after reset
since MCLK is disabled by default.
POWER DOWN
MCLK = ON
PWDN = 1
CS5371A CS5372A
DS748F3