V2DIP1-48 FTDI, Future Technology Devices International Ltd, V2DIP1-48 Datasheet - Page 9

• Manufacturer Part Number: V2DIP1-48
• Description: MOD MCU-USB HOST CTLR 24-DIP
• Manufacturer: FTDI, Future Technology Devices International Ltd
• Series: Vinculum-IIr

Specifications of V2DIP1-48

• Main Purpose: Interface, USB 2.0 Host/Controller
• Embedded: Yes, ASIC
• Utilized Ic / Part: VNC2-48Q
• Primary Attributes: Single A-Type Connector, UART / Parallel FIFO / SPI Interfaces
• Secondary Attributes: Second USB Port is Available via Pins, Traffic LEDs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 768-1057

3.3 I/O Configuration Using The Jumper Pin Header
Two three way jumper pin headers are provided to allow for simple configuration of the I/O on data and
control bus pins of the 48 pin QFN Vinculum-II. This is done by a combination of pulling up or pulling
down the 48 pin QFN Vinculum-II IOBUS25 (pin 46) and IOBUS26 (pin 47). The relevant portion of the
V2DIP1 48 module schematic is shown in
NOTE: This is only applicable when using VNC1L compatible firmware e.g. V2DAP2. Other wise the user
can set the pins for their own use.
Table 3.2 - V2DIP1 48 Port Selection Jumper Pins
Pull-Up
Pull-Up
Pull-Down
Pull-Down
Figure 3.3 - V2DIP1 48 On-Board Jumper Pin Configuration.
(VNC2-48Q pin 47)
IOBUS25
IOBUS25
IOBUS26
Copyright © 2010 Future Technology Devices International Limited
`
Figure 3.3
V2DIP1-48 VNC2-48 Development Module Datasheet Version 1.01
Pull-Up
Pull-Down
Pull-Up
Pull-Down
(VNC2-48Q pin 46)
IOBUS26
Document Reference No.: FT_000236
Clearance No.: FTDI# 153
Serial UART
SPI
Parallel FIFO
Serial UART
I/O Mode
8