ATA6622-EK Atmel, ATA6622-EK Datasheet - Page 3

• Manufacturer Part Number: ATA6622-EK
• Description: BOARD DEMO LIN SBC FOR ATA6622
• Manufacturer: Atmel

Specifications of ATA6622-EK

• Main Purpose: Interface, LIN
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ATA6622
• Primary Attributes: LIN-SBC (System-Basis-Chip) Transceiver, LIN 2.0, Voltage Regulator, Window Watchdog
• Secondary Attributes: 4 Power Modes: Pre-Normal, Normal, Sleep, Silent, 20-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4970B–AUTO–03/11
Table 1-3.
Table 1-4.
As the window watchdog of the Atmel
mode (Fail-safe mode), a periodic reset signal will be generated at the pin NRES as long as no
trigger signal can be received at the watchdog trigger input. Normally the connected microcon-
troller will be monitored by the watchdog, so it has to generate the required trigger signal as
described in
device. For the quick start it is sufficient to generate a square-wave signal with V
f = 75Hz at pin NTRIG or PTRIG for the Atmel ATA6621 or with f = 50Hz at pin NTRIG for the
Atmel ATA6622/24/26 (this is recommended only for testing purposes). In order to check that
the watchdog is triggered in the expected way, the reset pin NRES can be monitored until a
continuous high level is available.
Please note that the communication is still inactive in Pre-normal mode (Fail-safe mode).
In order to communicate via the LIN bus interface you have to switch to normal mode by
applying the VCC voltage (5V or 3.3V, as appropriate) at pin EN.
Fail-safe mode
Fail-safe mode
Normal mode
Normal mode
Mode
Mode
Section 2.3 on page 4
Atmel ATA6622
Atmel ATA6624/26
VCC
3.3V
3.3V
VCC
5V
5V
WD_OSC
WD_OSC
1.23V
1.23V
1.23V
1.23V
and in more detail in the datasheet of the corresponding
®
ATA6621/22/24/26 is already active in the Pre-normal
TEMP
TEMP
-
-
-
-
Atmel ATA6621/22/24/26
INH
INH
On
On
On
On
RXD
3.3V
3.3V
RXD
5V
5V
TXD dependent
TXD dependent
Recessive
Recessive
LIN
LIN
PP
Transceiver
Transceiver
= VCC and
Off
On
Off
On
3