DK-SI-4S100G2N Altera, DK-SI-4S100G2N Datasheet - Page 14

• Manufacturer Part Number: DK-SI-4S100G2N
• Description: KIT DEV STRATIX IV TRANSCEIVER
• Manufacturer: Altera
• Series: Stratix® IVr

Specifications of DK-SI-4S100G2N

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: EP4S100G2F40C2ES1
• Primary Attributes: *
• Secondary Attributes: *
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Stratix
• Silicon Core Number: EP4S
• Silicon Family Name: Stratix IV GT
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2603

5–2
Using the Board Update Portal to Update User Designs
Transceiver Signal Integrity Development Kit, Stratix IV GT Edition User Guide
f
1
4. Launch a web browser on a PC that is connected to the same network, and enter
5. Click Signal Integrity Development Kit to view the latest version of the
If the Board Update Portal cannot connect for some reason, then go to
www.altera.com/products/devkits/altera/kit-stratix-iv-gt-si.html
board has the latest kit software.
The Board Update Portal allows remote update of new FPGA configurations to the
user portion of the flash memory. Perform the following steps to update the user
memory on your board with a design downloaded from the Altera website.
1. Type the IP address displayed on the LCD into the web browser on the PC or use
2. Click the Browse button next to the Hardware File Name field and browse to the
3. Click Upload. The progress bar indicates the percent complete.
4. After the upload process is complete, the FPGA can be configured with the new
As long as the factory image is not overwritten, the Board Update Portal can be used
to update new user images in the same manner. If the factory memory image is
overwritten, it can be restored by following the instructions in
Design to the Flash Device” on page
the IP address from the LCD into the browser address bar. The Board Update
Portal web page appears in the browser page.
development kit software (the software version also appears on the CD-ROM).
1
1
the browser’s Back button to return to the main Board Update Portal web page.
new .flash file that was downloaded. If there is a software component to the
design, then include it in the same manner in the Software File Name field,
otherwise leave the field empty.
image. To do this, change jumper J62 to LOAD USER. To enable reconfiguration of
the FPGA, power up the board again or press RESET SW8. The design running in
flash is the selected .flash file.
If you download new software, double-click the downloaded .exe file to
begin the installation process.
Visit the Board Update Portal web page to check for additional new designs
that are not included on the CD-ROM and documentation updates.
A–4.
© December 2009 Altera Corporation
Chapter 5: Board Update Portal
“Restoring the Factory
to ensure that the
Board Update Portal