DK-SI-4S100G2N Altera, DK-SI-4S100G2N Datasheet - Page 11

• Manufacturer Part Number: DK-SI-4S100G2N
• Description: KIT DEV STRATIX IV TRANSCEIVER
• Manufacturer: Altera
• Series: Stratix® IVr

Specifications of DK-SI-4S100G2N

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: EP4S100G2F40C2ES1
• Primary Attributes: *
• Secondary Attributes: *
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Stratix
• Silicon Core Number: EP4S
• Silicon Family Name: Stratix IV GT
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2603

Introduction
Powering Up the Board
© December 2009 Altera Corporation
The instructions in this chapter explain how to power up the signal integrity
development board.
To power up the board, perform the following steps:
1. Verify that the MAX/JTAG jumper J26 is OFF, and that the mini-DIP switch SW2
2. Connect the power cable to the board and plug the other end into a power outlet.
3. Connect the DC adapter (+16 V, 3.75 A) to the DC power jack (J1).
4. Ensure the POWER switch (SW1) is in the ON position. When power is supplied to
After the board powers up, the on-board flash memory, which ships preprogrammed
with the factory design, automatically configures the Stratix IV GT device. The
FACTORY LED illuminates, signaling that the Stratix IV GT device is configured with
the preprogrammed factory design.
Switch Pin
Label
Position
settings located adjacent to jumper J62 match the settings in the following table:
1
c
the board, LED D3 turns on indicating that the board has power.
Use only the supplied 16-V power supply. Power regulation circuitry on the
board could be damaged by supplies greater than 16 V.
Maintain these settings as they control the speed of the board oscillator. For
more information, refer to the
Stratix IV GT Edition Reference
up or 0
SW2.1
S0
Transceiver Signal Integrity Development Kit, Stratix IV GT Edition User Guide
down or 1
4. Development Board Setup
Manual.
Transceiver Signal Integrity Development Kit,
SW2.2
S1
down or 1
SW2.3
S2
down or 1
SW2.4
S3