M0120SD-201MDBR1-1 Newhaven Display, M0120SD-201MDBR1-1 Datasheet - Page 20

• Manufacturer Part Number: M0120SD-201MDBR1-1
• Description: MODULE VF CHAR 1X20 4.9MM
• Manufacturer: Newhaven Display

Specifications of M0120SD-201MDBR1-1

• Outline L X W X H: 150.00mm x 32.00mm x 25.50mm
• Viewing Area: 92.70mm L x 4.90mm W
• Display Format: 20 x 1
• Display Type: Character
• Format: 5 x 7 Dots
• Voltage - Supply: 4.5 V ~ 5.5 V
• Character Size: 4.90mm H x 3.40mm W
• Operating Temperature: -20°C ~ 70°C
• Product: Character Display Modules
• Character Count X Line: 20 x 1
• Module Size (w X H X T): 150 mm x 32 mm x 25.5 mm
• Voltage Rating: 4.5 V to 5.5 V
• Operating Temperature Range: - 20 C to + 70 C
• Dot Format: 5 x 7
• Viewing Area (w X H): 92.7 mm x 4.9 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Interface: -
• Number Of Dots: -
• Lead Free Status / Rohs Status: Details

7. 0
NOTE: Newhaven Display reserves the right to change or modify this spec and or design without notice in order
Note: The address counter (ACC) is automatically incremented or decremented by 1 after the write
7.10 Avoid using the module where excessive noise interference is expected. Noise may affects the
7.1 Avoid applying excessive shock or vibration beyond the specification for the VFD module.
7.2 Since VFDs are made of glass material, careful handling is required.
7.3 When mounting the VFD module to your system, leave a slight gap between the VFD glass and
7.5 Slow starting power supply may cause non-operation because one chip Mico won’t be reset.
7.6 Exceeding any of maximum ratings may cause the permanent damage.
7.7 Since the VFD modules contain high voltage source, careful handing is required during
7.8 When the power is turned off, the capacitor dose not discharge immediately.
7.9 The power supply must be capable of providing at least 3 times the rated current, because the surge
7.11 Since all VFD modules contain C-MOS ICs, anti-static handing procedures are always required.
7.4 Avoid plugging or unplugging the interface connection with the power on, otherwise it may cause
to improve the design or ensure the quality of this product.
OPERATING RECOMMENDATIONS
instructions to CG-RAM or DD-RAM are executed. The RAM data selected by the ACC cannot be
read out at this time even if read instructions are executed. Therefore, to correctly read data,
execute either the address set instruction or cursor shift instruction (only with DD-RAM), then just
before reading the desired data, execute the read instruction from the second time the read
instruction is sent.
interface cable less than 50cm.
glass.
your front panel. The module should be mounted without stress to avoid flexing of the PCB.
powered on.
current can be more than 3 times the specified current consumption when the power is turned on.
Interface signal and causes improper operation. And it is important to keep the length of the
i.e. Direct impact with hard material to the glass surface (especially exhaust tip) may crack the
the severe damage to input circuitry.