M0120SD-201MDBR1-1 Newhaven Display, M0120SD-201MDBR1-1 Datasheet - Page 19

• Manufacturer Part Number: M0120SD-201MDBR1-1
• Description: MODULE VF CHAR 1X20 4.9MM
• Manufacturer: Newhaven Display

Specifications of M0120SD-201MDBR1-1

• Outline L X W X H: 150.00mm x 32.00mm x 25.50mm
• Viewing Area: 92.70mm L x 4.90mm W
• Display Format: 20 x 1
• Display Type: Character
• Format: 5 x 7 Dots
• Voltage - Supply: 4.5 V ~ 5.5 V
• Character Size: 4.90mm H x 3.40mm W
• Operating Temperature: -20°C ~ 70°C
• Product: Character Display Modules
• Character Count X Line: 20 x 1
• Module Size (w X H X T): 150 mm x 32 mm x 25.5 mm
• Voltage Rating: 4.5 V to 5.5 V
• Operating Temperature Range: - 20 C to + 70 C
• Dot Format: 5 x 7
• Viewing Area (w X H): 92.7 mm x 4.9 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Interface: -
• Number Of Dots: -
• Lead Free Status / Rohs Status: Details

6.2.9 Read Busy Flag and Address
(1) Loads a new 7-bit address into the address counter (ACC).
(2) Sets the address counter (ACC) to point to the DD-RAM.
Once the “Set DD-RAM Address” instruction has been executed, the contents of the address counter (ACC)
will be automatically modified after each access of DD-RAM, as selected by the “Entry Mode Set”
instruction.
Table-16 Valid DD-RAM address Ranges
The next instruction will not be accepted until BF is reset to 0.Check the BF status before the next write
operation. At the same time, the value of the address counter (ACC) in binary AAAAAAA is read out. This
address counter (ACC) is used by both CG-RAM and DD-RAM address and its value is determined by the
previous instruction. The address counter are the same as for instructions set CG-RAM address and set
DD-RAM address.
This instruction writes 8-bit binary data (DB7 to DB0) from CG-RAM or DD-RAM.
The previous designation determines whether CG-RAM or DD-RAM is to be read.
Before entering this read instruction, either CG-RAM or DD-RAM address set instruction must be executed.
If not executed, the first read data will be invalid. When serially executing read instructions, the next address
data is normally read from the second read. The address set instructions need not be executed just before this
read instruction when shifting the cursor shift instruction (when reading out DD-RAM).
The operation of the cursor shift instruction is the same as the set DD-RAM address instruction.
After a read, the entry mode automatically increases or decreases the address by 1.
This instruction
RS=0, R/W=1
RS=1, R/W=0
DB7 DB6 DB5 DB4
DB7 DB6 DB5
BF
1
st
line
Data Read
Number of Character
DB4
DB3 DB2 DB1 DB0
ACC
DB3 DB2 DB1 DB0
10
Address Range
00H to 13H