PC4SF21YTZBF Sharp Microelectronics, PC4SF21YTZBF Datasheet - Page 8

• Manufacturer Part Number: PC4SF21YTZBF
• Description: PHOTOCOUPLER TRIAC OUT ZC 6-DIP
• Manufacturer: Sharp Microelectronics

Specifications of PC4SF21YTZBF

• Voltage - Isolation: 5000Vrms
• Number Of Channels: 1
• Voltage - Off State: 800V
• Output Type: AC, Triac, Zero Cross
• Current - Gate Trigger (igt) (max): 7mA
• Current - Hold (ih): 100µA
• Current - Dc Forward (if): 50mA
• Current - Output / Channel: 100mA
• Mounting Type: Through Hole
• Package / Case: 6-DIP
• Output Device: Triac
• Isolation Voltage: 5000 Vrms
• Peak Output Voltage (vdrm): 800 V
• Maximum Input Voltage: 1.4 V
• Maximum Output Voltage: 560 VAC
• Minimum Trigger Current: 7 mA (Max)
• Configuration: 1
• Maximum Continuous Output Current: 100 mA
• Maximum Input Current: 50 mA
• Maximum Operating Temperature: + 100 C
• Maximum Reverse Diode Voltage: 6 V
• Maximum Turn-on Time: 50 us
• Minimum Operating Temperature: - 30 C
• Mounting Style: Through Hole
• Typical Input Voltage: 1.2 V
• Zero-crossing Circuit: Yes
• Zero-crossing Voltage: 20 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 425-2618-5

■ Design Considerations
● Degradation
● Recommended Foot Print (reference)
● Design guide
SMT Gullwing Lead-form
In order for the Phototriac to turn off, the triggering current (I
Please refrain from using these devices in a direct drive configuration. These Phototriac Coupler are
intended to be used as triggering device for main Triacs. Please ensure that the output rating of these
devices will be sufficient for triggering the main output Triac of your choice. Failure to do may result in
malfunctions.
For applications with inductive loads such as motors,please use caution in utilizing a zero crossing type
Phototraiac Coupler as this may cause undesired operations due to the phase difference between voltage
and current of load.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit. Please keep in mind the Sharp Phototriac Coupler
incorporate superrior dV/dt ratings which can eliminate the need for a snubber circuit.
For over voltage protection, a Varistor may be used.
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
2.2
8.2
8
Wide SMT Gullwing Lead-form
F
) must be 0.1mA or less.
2.2
10.2
PC4SF21YVZ Series
Sheet No.: D2-A08301EN
(Unit : mm)