PESD5V0L4UF T/R NXP Semiconductors, PESD5V0L4UF T/R Datasheet - Page 10

• Manufacturer Part Number: PESD5V0L4UF T/R
• Description: TVS Diode Arrays DIODE ARRAY ESD TAPE-7
• Manufacturer: NXP Semiconductors

Specifications of PESD5V0L4UF T/R

• Product Category: TVS Diode Arrays
• Rohs: yes
• Polarity: Unidirectional
• Breakdown Voltage: 6.46 V
• Clamping Voltage: 13 V
• Operating Voltage: 5 V
• Peak Surge Current: 2.5 A
• Minimum Operating Temperature: - 65 C
• Maximum Operating Temperature: + 150 C
• Dimensions: 1.05(Max) mm W x 1.5(Max) mm L
• Package / Case: SOT-886
• Peak Pulse Power Dissipation: 30 W
• Factory Pack Quantity: 5000
• Part # Aliases: PESD5V0L4UF,115

NXP Semiconductors
7. Application information
PESDXL4UF_G_W_4
Product data sheet
The devices are designed for the protection of up to four unidirectional data or signal lines
from the damage caused by ESD and surge pulses. The devices may be used on lines
where the signal polarities are both, positive and negative with respect to ground. The
devices provide a surge capability of 30 W per line for an 8/20 s waveform each.
Circuit board layout and protection device placement
Circuit board layout is critical for the suppression of ESD, Electrical Fast Transient (EFT)
and surge transients. The following guidelines are recommended:
1. Place the device as close to the input terminal or connector as possible.
2. The path length between the device and the protected line should be minimized.
3. Keep parallel signal paths to a minimum.
4. Avoid running protected conductors in parallel with unprotected conductors.
5. Minimize all Printed-Circuit Board (PCB) conductive loops including power and
6. Minimize the length of the transient return path to ground.
7. Avoid using shared transient return paths to a common ground point.
8. Ground planes should be used whenever possible. For multilayer PCBs, use ground
Fig 9. Application diagram
ground loops.
vias.
Low capacitance unidirectional quadruple ESD protection diode arrays
unidirectional protection of 4 lines
Rev. 04 — 28 February 2008
1
2
3
DUT
5
4
bidirectional protection of 3 lines
n.c.
PESDxL4UF/G/W
1
2
3
data- or transmission lines
DUT
006aab126
5
4
© NXP B.V. 2008. All rights reserved.
10 of 17