MIKROE-411 mikroElektronika, MIKROE-411 Datasheet - Page 6

• Manufacturer Part Number: MIKROE-411
• Description: Development Boards & Kits - PIC / DSPIC EASYPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-411

• Rohs: yes
• Product: Development Kits
• Core: PIC
• Interface Type: CAN, IDC10, JTAG, RS-232, USB
• Operating Supply Voltage: 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD are not included
• Dimensions: 265 mm x 220 mm
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• For Use With: PIC16F887

6
MikroElektronika
1.0. Connecting the System to your PC
Use the USB cable to connect the EasyPIC6 development system to your PC. One end of the USB cable provided with a connector of the USB
B type should be connected to the development system as shown in Figure 1-2, whereas the other end of the cable (USB A type) should be
connected to your PC. When establishing a connection, make sure that jumper J6 is placed in the USB position as shown in Figure 1-1.
Follow the instructions for installing USB drivers and the
PIC microcontrollers without having these devices installed. In case that you already have some of the MikroElektronika’s compilers installed
on your PC, there is no need to reinstall the
Turn on your development system by setting the power supply switch to the ON position. Two LEDs marked as ‘POWER’ and ‘USB LINK’ will
be automatically turned on to indicate that your development system is ready for use. Use the
microcontroller and employ the board to test and develop your projects.
J6 power supply selector
Power OFF/ON switch
If you use some additional modules, such as LCD, GLCD, extra boards etc., it is necessary to place them properly on the develop-
ment system before it is turned on. Otherwise, they can be permanently damaged.
Placing additional modules on the board
DC connector
Power supply
USB connector
programmer as it will be automatically installed along with compiler installation.
programmer provided in the relevant manuals. It is not possible to program
1
Connecting USB cable (jumper J6 in the USB position)
EasyPIC6 Development System
programmer to dump a code into the
2