MIKROE-1153 mikroElektronika, MIKROE-1153 Datasheet - Page 15

• Manufacturer Part Number: MIKROE-1153
• Description: Development Boards & Kits - PIC / DSPIC EASYPIC v7 dsPIC30 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-1153

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: dsPIC30 MCUs
• Core: dsPIC
• Interface Type: CAN, RS-232, USB
• Operating Supply Voltage: 3.3 V, 5 V
• Dimensions: 266 mm x 220 mm

EasyPIC
Toolbar
Icon
for dsPIC30
Command Name
Start Debugger
Run/Pause Debugger
Stop Debugger
Step Into
Step Over
Step Out
Run To Cursor
Toggle Breakpoint
Show/Hide breakpoints
Clears breakpoints
Jump to interrupt
®
v7
mikroICD
Here is a short overview of which debugging commands are supported in mikroElektronika compilers. You can see what each command does,
and what are their shortcuts when you are in debugging mode. It will give you some general picture of what your debugger can do.
Shortcut
[F9]
[F6]
[Ctrl + F2]
[F7]
[F8]
[Ctrl + F8]
[F4]
[F5]
[Shift+F4]
[Shift+Ctrl+F5]
[F2]
™
commands
Description
Starts Debugger.
Run/Pause Debugger.
Stops Debugger.
Executes the current program line, then halts. If the executed
program line calls another routine, the debugger steps into the
routine and halts after executing the first instruction within it.
Executes the current program line, then halts. If the executed program
line calls another routine, the debugger will not step into it. The whole
routine will be executed and the debugger halts at the first instruction
following the call.
Executes all remaining program lines within the subroutine. The
debugger halts immediately upon exiting the subroutine.
Executes the program until reaching the cursor position.
Toggle breakpoints option sets new breakpoints or removes those
already set at the current cursor position.
Shows/Hides window with all breakpoints
Deletes selected breakpoints
Opens window with available interrupts (doesn't work in mikroICD
mode)
page 15
™