MIKROE-455 mikroElektronika, MIKROE-455 Datasheet - Page 6

• Manufacturer Part Number: MIKROE-455
• Description: Development Boards & Kits - 8051 EASY8051 V6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-455

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: AT89S8253
• Core: 8051
• Interface Type: CAN, MMC/SD, RS-232, USB
• Operating Supply Voltage: 5 V, 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, GLCD, LCD, DS1820, Serial Cable not included
• Dimensions: 265 mm x 220 mm
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• For Use With: AT89S8253

6
1.0. Connecting the System to your PC
Follow the instructions provided in the relevant manuals and install the
drivers are necessary for the proper operation of the on-board programmer.
In case you already have some of the Mikroelektronika’s compilers installed on your PC, there is no need to reinstall drivers as they
will automatically be installed along with the compiler.
Use the USB cable to connect the Easy8051 v6 development system to your PC. One end of the USB cable with a connector of the
USB B type should be connected to the development system, as shown in Figure 1-2, whereas the other end of the cable (USB A
type) should be connected to your PC. When establishing a connection, make sure that jumper J11 is placed in the USB position as
shown in Figure 1-1.
Turn on your development system by setting the POWER SUPPLY switch to the ON position. Two LEDs referred to by POWER and
USB LINK will illuminate to indicate that your development system is ready to use. Use the on-board 8051prog programmer and
MikroElektronika
J11 power supply
selector
POWER SUPPLY
switch
If you use additional modules, such as LCD, GLCD etc., it is necessary to place them properly on the develop-
ment board before it is turned on. Otherwise, both additional modules and development system can be permanently damaged.
Refer to Figure 1-3 for their proper placing.
program to dump a code into the microcontroller and employ the board to test and develop your projects.
Placing additional modules on the board
DC connector
Power supply
USB connector
1
Connecting USB cable
program and USB drivers from the product CD. USB
Easy8051 v6 Development System
2