AT25DF161-MH-T Atmel, AT25DF161-MH-T Datasheet - Page 21

• Manufacturer Part Number: AT25DF161-MH-T
• Description: IC FLASH 16MBIT 100MHZ 8UDFN
• Manufacturer: Atmel

Specifications of AT25DF161-MH-T

• Format - Memory: FLASH
• Memory Type: DataFLASH
• Memory Size: 16M (2M x 8)
• Speed: 100MHz
• Interface: SPI, RapidS
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-UDFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Atmel AT25DF161
Figure 9-4.
Unprotect Sector
CS
SCK
SI
SO
9.5
Global Protect/Unprotect
The Global Protect and Global Unprotect features can work in conjunction with the Protect Sector and Unprotect Sector
functions. For example, a system can globally protect the entire memory array and then use the Unprotect Sector
command to individually unprotect certain sectors and individually reprotect them later by using the Protect Sector
command. Likewise, a system can globally unprotect the entire memory array and then individually protect certain sectors
as needed.
Performing a Global Protect or Global Unprotect is accomplished by writing a certain combination of data to the Status
Register using the Write Status Register Byte 1 command (see
“Write Status Register Byte 1” on page 33
for command
execution details). The Write Status Register command is also used to modify the SPRL (Sector Protection Registers
Locked) bit to control hardware and software locking.
To perform a Global Protect, the appropriate WP pin and SPRL conditions must be met, and the system must write a logical
“1” to bits five, four, three, and two of the first byte of the Status Register. Conversely, to perform a Global Unprotect, the
same WP and SPRL conditions must be met but the system must write a logical “0” to bits five, four, three, and two of the
first byte of the Status Register.
Table 9-2
details the conditions necessary for a Global Protect or Global Unprotect to be
performed.
Sectors that have been erase or program suspended must remain in the unprotected state. If a Global Protect operation is
attempted while a sector is erase or program suspended, the protection operation will abort, the protection states of all
sectors in the Flash memory array will not change, and WEL bit in the Status Register will be reset back to a logical “0”.
21
3687E–DFLASH–11/10