AT25DF161-SSH-T Atmel, AT25DF161-SSH-T Datasheet - Page 8

• Manufacturer Part Number: AT25DF161-SSH-T
• Description: IC FLASH 16MBIT 100MHZ 8SOIC
• Manufacturer: Atmel

Specifications of AT25DF161-SSH-T

• Format - Memory: FLASH
• Memory Type: DataFLASH
• Memory Size: 16M (2M x 8)
• Speed: 100MHz
• Interface: SPI, RapidS
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7.
7.1
8
Read Commands
Read Array
The Read Array command can be used to sequentially read a continuous stream of data from the device by simply
providing the clock signal once the initial starting address has been specified. The device incorporates an internal address
counter that automatically increments on every clock cycle.
Three opcodes (1Bh, 0Bh, and 03h) can be used for the Read Array command. The use of each opcode depends on the
maximum clock frequency that will be used to read data from the device. The 0Bh opcode can be used at any clock
frequency up to the maximum specified by f
to the maximum specified by f
clock frequency up to the maximum specified by f
should be reserved to systems employing Atmel
To perform the Read Array operation, the CS pin must first be asserted and the appropriate opcode (1Bh, 0Bh, or 03h)
must be clocked into the device. After the opcode has been clocked in, the three address bytes must be clocked in to
specify the starting address location of the first byte to read within the memory array. Following the three address bytes,
additional dummy bytes may need to be clocked into the device depending on which opcode is used for the Read Array
operation. If the 1Bh opcode is used, then two dummy bytes must be clocked into the device after the three address
bytes. If the 0Bh opcode is used, then a single dummy byte must be clocked in after the address bytes.
After the three address bytes (and the dummy bytes or byte if using opcodes 1Bh or 0Bh) have been clocked in,
additional clock cycles will result in data being output on the SO pin. The data is always output with the MSB of a byte first.
When the last byte (1FFFFFh) of the memory array has been read, the device will continue reading back at the beginning
of the array (000000h). No delays will be incurred when wrapping around from the end of the array to the beginning of
the array.
Deasserting the CS pin will terminate the read operation and put the SO pin into a high-impedance state. The CS pin can
be deasserted at any time and does not require that a full byte of data be read.
Figure 7-1.
Atmel AT25DF161
SCK
SO
CS
SI
Read Array – 1Bh Opcode
RDLF
. The 1Bh opcode allows the highest read performance possible and can be used at any
CLK
, and the 03h opcode can be used for lower frequency read operations up
®
MAX
RapidS
; however, use of the 1Bh opcode at clock frequencies above f
™
protocol.
3687E–DFLASH–11/10
CLK