M95640-WDW6TP STMicroelectronics, M95640-WDW6TP Datasheet - Page 27

• Manufacturer Part Number: M95640-WDW6TP
• Description: IC EEPROM 64KBIT 10MHZ 8TSSOP
• Manufacturer: STMicroelectronics

Specifications of M95640-WDW6TP

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 64K (8K x 8)
• Speed: 10MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8699-2; M95640-WDW6TP

M95640, M95640-W, M95640-R, M95640-DR
Figure 16. Read Lock Status sequence
6.10
Lock ID
The Lock ID instruction permanently locks the Identification Page in read-only mode. Before
this instruction can be accepted, a Write Enable (WREN) instruction must have been
executed. The Lock ID instruction is issued by driving Chip Select (S) low, sending the
instruction code, the address and a data byte on Serial Data input (D), and driving Chip
Select (S) high. In the address sent, A10 must be equal to 1, all other address bits are Don't
Care. The data byte sent must be equal to the binary value xxxx xx1x, where x = Don't Care.
Chip Select (S) must be driven high after the rising edge of Serial Clock (C) that latches in
he eighth bit of the data byte, and before the next rising edge of Serial Clock (C). Otherwise,
the Lock ID instruction is not executed.
Driving Chip Select (S) high at a byte boundary of the input data triggers the self-timed write
cycle which duration is t
instruction sequence is shown in
Figure 17. Lock ID sequence
W
(specified in
Doc ID 16877 Rev 15
Figure
Table
17.
18,
Table
19,
Table 20
and
Table
21). The
Instructions
27/48