PPC440EPX-NPAFFFTS AMCC [Applied Micro Circuits Corporation], PPC440EPX-NPAFFFTS Datasheet - Page 91

• Manufacturer Part Number: PPC440EPX-NPAFFFTS
• Description: PowerPC 440EPx Embedded Processor
• Manufacturer: AMCC [Applied Micro Circuits Corporation]

Revision 1.26 – October 15, 2007
Initialization
The PPC440EPx provides the option for setting initial parameters based on default values or by reading them from
a slave PROM attached to the IIC0 bus (see “Serial EEPROM” below). Some of the default values can be altered
by strapping on external pins (see “Strapping” below).
Strapping
While the SysReset input pin is low (system reset), the state of certain I/O pins is read to enable certain default
initial conditions prior to PPC440EPx start-up. The actual capture instant is the nearest reference clock edge
before the deassertion of reset. These pins must be strapped using external pull-up (logical 1) or pull-down
(logical 0) resistors to select the desired default conditions. These pins are used for strap functions only during
reset. Following reset they are used for normal functions. The signal names assigned to the pins for normal
operation are shown in parentheses following the pin number.
Note: When UART0_DCD, UART0_DSR and UART0_CTS are used functionally, the pin straps should be isolated
from the UART transceiver during reset as the transceiver may overdrive the pin straps and cause the PPC440EPx
to read incorrect straps.
The following table lists the strapping pins along with their functions and strapping options:
Serial EEPROM
During reset, initial conditions other than those obtained from the strapping pins can be read from a ROM device
connected to the IIC0 port. At the de-assertion of reset, if the bootstrap controller is enabled, the PPC440EPx
sequentially reads 16 B from the ROM device on the IIC0 port and sets the SDR0_SDSTP0, SDR0_SDSTP1,
SDR0_SDSTP2 and SDR0_SDSTP3 registers accordingly.
The initialization settings and their default values are covered in detail in the PowerPC 440EPx User’s Manual.
AMCC Proprietary
Preliminary Data Sheet
Table 27. Strapping Pin Assignments
Serial device is disabled. Each of the six options (A–
F) is a combination of boot source, boot-source
width, and clock frequency specifications. Refer to
the IIC Bootstrap Controller chapter in the
PPC440EPx Embedded Processor User’s Manual
for details.
Serial device is enabled. The option being selected is
the IIC0 slave address that will respond with
strapping data.
Function
G (0xA8)
H (0xA4)
Option
A
B
C
D
E
F
440EPx – PPC440EPx Embedded Processor
(UART0_DCD)
C28
0
0
0
0
1
1
1
1
(UART0_DSR)
Pin Strapping
C29
0
0
1
1
0
1
0
1
(UART0_CTS)
A29
0
1
0
1
0
0
1
1
91