UPD65MC NEC, UPD65MC Datasheet - Page 29

• Manufacturer Part Number: UPD65MC
• Description: 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
• Manufacturer: NEC

8. SYSTEM CLOCK OSCILLATOR
The system clock oscillator consists of oscillators for ceramic resonators (f
The system clock oscillator stops its oscillation when reset or in STOP mode.
Caution When using the system clock oscillator, wire area indicated by the dotted-line in the diagram
as follows to reduce the effects of the wiring capacitance, etc.
• Make the wiring as short as possible.
• Do not allow the wiring to intersect other signal lines. Do not wire close to lines through
• Make sure that the point where the oscillator capacitor is installed is always at the same
• Do not extract signals from the oscillator.
which large fluctuating currents flow.
electric potential as the ground. Never earth with a ground pattern through which large
currents flow.
Ceramic resonator
X
OUT
Figure 8-1. System Clock
Data Sheet U14380EJ2V0DS00
PD64A, 65
X
IN
GND
X
= 2.4 to 8 MHz).
PD64A, 65
29